z probe servo not work anet a8

[ISU000]

hi, i test in all input 27,28,29,30 but with m280 don't move servo (3D Touch) the 3D Touch with marlin 3.1.6 in my anet work well but without nextion 7 lcd.

This is my configuration:
Configuration_Overall.h.zip

[MagoKimbra]

#define SERVO0_PIN 30 in configuration_overall????? WHY??? The pin is defined in configuration_pins!!

[ISU000]

Yes i know but in original input 27 in board 100 anet when i put servo cable de light 1 go on, for test i change inputs in board configuration 27,28,29,30 and 30 servo dont move, i test with normal servo and not move. In marlin 3.1.6 with anet board work perfect. I put in overall for make test but servo not work. This moning i test with ramps 1.4 board and work perfect. Thanks Iker El 27 dic. 2017 15:51, "MagoKimbra" <[email protected]> escribió: #define SERVO0_PIN 30 in configuration_overall????? WHY??? The pin is defined in configuration_pins!! — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub, or mute the thread.

[MagoKimbra]

Ok you must change on your board file

[ISU000]

Yes El 27 dic. 2017 17:07, "MagoKimbra" <[email protected] <mailto:[email protected]>> escribió: Ok you must change on your board file — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#180 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AhOSGmOAdjjm7ino4vMKqAWLdX167jmGks5tEmsngaJpZM4RMUGO>.